Radome for 3ft Dish Antenna

Ubiquiti Radome for 3ft Dish Antenna – Weather Protection That Pays for Itself

A 3ft dish on a mast is a sail in a storm. Every gust pushes against it, every winter coats it in ice, and every degree of misalignment costs you link margin. The Ubiquiti Radome for 3ft dish antennas solves all three problems with one clip-on cover: an RF-transparent shield that blocks rain, snow, ice, and debris while dramatically cutting the wind load on your dish and mount.

If you’re running a 3ft (36-inch) Ubiquiti RocketDish or airFiber-X dish on a long-haul point-to-point link, this is the cheapest insurance you can buy for it.

Why Fit a Radome to Your 3ft Dish?

1. Slashed Wind Load = A Link That Stays Aligned

An open dish catches wind like a bowl; a radome-covered dish sheds it like a dome. That reduced drag means less mast stress, less vibration, and most importantly a dish that holds the precise alignment your long-distance link depends on. On exposed NZ ridgelines and coastal sites, this alone justifies the purchase.

2. Weather Sealing for Rain, Ice, Snow and Debris

The radome keeps the dish face clean and dry year-round. No ice sheet building up in the reflector through a Central Otago winter, no salt and grime accumulating on a coastal install, no birds nesting where your signal lives. A clean, dry reflector performs consistently in conditions that degrade an exposed one.

3. RF-Transparent by Design

The cover is engineered to pass your signal through with negligible loss protection without a performance penalty. By preventing water film, ice, and debris buildup on the reflector itself, a radome typically improves real-world link consistency compared with a bare dish in bad weather.

4. UV-Stabilised, Lightweight Construction

Built from UV-resistant weatherproof plastic, the radome survives years of harsh sun and storms without becoming brittle, while adding minimal weight to the antenna assembly no mount upgrades or structural changes required.

5. Longer Equipment Life, Fewer Tower Climbs

Every climb to clean, realign, or de-ice a dish costs time and money and rural or elevated sites make each callout expensive. Shielding the dish cuts that maintenance cycle down and extends the working life of the antenna underneath.

Key Features

• Purpose-built fit for 3ft (36-inch) Ubiquiti dish antennas — clean lines, secure attachment
• Wind load reduction that protects alignment and eases stress on masts and mounts
• Full-face weather shield against rain, snow, ice, dust, salt spray, and debris
• RF-transparent material — protection with no meaningful signal trade-off
• UV-stabilised construction for long outdoor service life
• Lightweight and simple to fit — installs with basic tools in minutes
• Ideal for exposed sites: ridgelines, coastal locations, and high-wind regions

Who Needs This Radome?

• WISPs and network operators — protect backhaul links that customers depend on, and cut truck rolls to remote towers.
• Rural and remote property links — long-haul point-to-point connections in exposed country where nobody wants to climb a mast in July.
• Coastal installations — keep salt spray off the reflector and corrosion at bay.
• High-wind sites — anywhere dish misalignment is a recurring problem, the radome addresses the cause rather than the symptom.

Installation

Fitting takes minutes, not hours:

1. Confirm your dish is a compatible 3ft Ubiquiti model.
2. Position the radome over the dish face.
3. Secure it using the integrated attachment points.
4. Verify your link signal levels — expect them steady or improved.

No specialist tools, no structural changes, and no need to take the link down for more than the installation itself.

Compatibility

Designed for 3ft (36-inch) Ubiquiti dish antennas, including the RocketDish 5GHz 30/31 dBi series and 3ft airFiber-X dishes.

Note: PowerBeam units use smaller dishes with their own dedicated snap-on radomes — this 3ft radome is not the right part for a PowerBeam. If you’re unsure which radome matches your dish, check the model number on your antenna or ask us before ordering.

FAQs

Do I really need a radome on my 3ft dish?

It’s optional but strongly recommended for exposed outdoor installs. Wind load reduction and weather sealing directly translate into fewer alignment issues, less maintenance, and a more consistent link — especially on ridgeline, rural, and coastal sites.

Will the radome weaken my signal?

No. The cover is RF-transparent, and by keeping water, ice, and grime off the reflector it typically makes real-world performance more consistent than an unprotected dish in bad weather.

Can I install it myself?

Yes — installation takes a few minutes with basic tools. If your dish is on a high mast or tower, follow your normal working-at-height practices.

How does it help in high-wind areas?

The smooth dome profile sheds wind that an open dish would catch, reducing drag, vibration, and the gradual misalignment that erodes long-distance link quality.

Will it fit a non-Ubiquiti 3ft dish?

It’s designed specifically for Ubiquiti 3ft dishes. It may physically fit some third-party 36-inch reflectors, but fit and attachment aren’t guaranteed — check dimensions before ordering.