Ubiquiti POE 54V 80W

Ubiquiti PoE 54V 80W Power Supply for EdgePoint

Clean power to the edge one cable, one adapter

The Ubiquiti PoE 54V 80W is a dedicated power supply that feeds both electricity and data to your EdgePoint router or switch over a single Ethernet cable. No separate power run to the device, no extra outlet at the mount point just this adapter at the indoor end and a cable to where the EdgePoint sits. For outdoor wireless links, remote switching, and edge-of-network installs where running mains to the device isn’t practical, it keeps the setup simple and the power steady.

54V / 80W enough for the full EdgePoint range

The adapter delivers a stable 54-volt output at up to 80 watts, giving EdgePoint devices the headroom they need to run at full capacity without power-related drops or reboots. That 80W budget covers the EdgePoint R6, R8, and other compatible models comfortably, even under sustained load.

Power and data on one cable

PoE eliminates the second cable. The adapter injects power onto the Ethernet run, so the EdgePoint at the other end draws both its network connection and its electricity from a single cable. That’s one less cable to route, one less weatherproof junction outdoors, and a significantly cleaner install especially on poles, towers, and exterior walls.

Built for the job, not just the spec sheet

Ubiquiti built this supply for continuous, unattended operation in the kind of environments EdgePoint gear lives in outdoor cabinets, remote sites, rooftops. It’s designed for efficient heat dissipation, minimal energy loss, and the long-term reliability that matters when the device is somewhere you don’t visit often.

Works across the Ubiquiti PoE ecosystem

While it’s optimised for EdgePoint routers and switches, the 54V 80W adapter is also compatible with other Ubiquiti devices that accept 54V passive PoE input at this wattage. That makes it a useful spare or replacement across a Ubiquiti deployment, not just a single-purpose accessory.

Setup in four steps

1. Plug the power supply into a mains outlet
2. Connect an Ethernet cable from the adapter’s PoE port
3. Run the cable to your EdgePoint device and plug in
4. Confirm the connection — check the LED indicators on both ends

No configuration, no software. Power flows, the device boots, and the network is live.

Specifications

Ideal for

• EdgePoint outdoor deployments — poles, towers, cabinets, and remote enclosures
• Wireless backhaul sites — powering the edge switch that feeds your radios
• Surveillance infrastructure — remote switching points in a camera network
• Enterprise edge networking — anywhere an EdgePoint sits away from a convenient power source
• Replacements and spares — a matched supply for existing EdgePoint installs

Keep the edge powered

The Ubiquiti PoE 54V 80W does one job and does it well: reliable, clean power to your EdgePoint over a single cable. Add it to your order, and if you need help confirming compatibility with your specific device or planning a remote install, get in touch and we’ll sort it.