T5-4.7 Inch E-paper – PH 2.0 holder

LILYGO® TTGO T5-4.7 Inch E-paper ESP32 V3 Version 16MB FLASH 8MB PSRAM WIFI/Bluetooth Module Development Board for Arduino.

Sold out, already upgraded to the new version! Check here:

E-paper V2.3

Note: 

1. The Clamp Edge of the 18650 Battery Holder is relatively sharp.
2. Be careful not to scratch the battery cover when installing.

Specification

T5 4.7-inch E-Paper
T5 4.7-inch E-Paper is another version of the T5 series of electronic ink screens.
The T5 series of ink screen versions include 1.02, 1.54, 2.13, etc., from small to large electronic ink screen versions.

We have been committed to low-power design optimization.
This 4.7-inch version continues the low-power design, the sleep mode current is about 170uA, and two optional battery modes are designed on the back.

One is PH 2.0 pitch 2pin interface, and the other is a 18650 battery metal connector.
Two power supply modes for you to choose from.
A 6pin touch screen interface is reserved as an optional accessory to facilitate your application.

There are 5 buttons reserved on the side, 3 of which are custom buttons, which can define functions flexibly. One is the reset button.

GitHub Link：

LilyGo-EPD47

3D printed shell file:

3D_file

LILYGO T5-4.7 E-Paper is attached to the refrigerator by soldering magnetic screw:

https://www.youtube.com/watch?spm=a2g0o.detail.1000023.4.357f3f30Ye72n6&v=rzsPAy_RVZI

1. Size

2. Pin Diagram

18650 9102 Chip

1 X T5-4.7 inch E-paper 18650 battery holder version（Without battery）

PH 2.0 9102 Chip

1 X T5-4.7 inch E-paper PH 2.0 holder version（Without battery）